The SSD Anthology: Understanding SSDs and New Drives from OCZ
by Anand Lal Shimpi on March 18, 2009 12:00 AM EST- Posted in
- Storage
New vs Used SSD Performance
We begin our look at how the overhead of managing pages impacts SSD performance with iometer. The table below shows iometer random write performance; there are two rows for each drive, one for “new” performance after a secure erase and one for “used” performance after the drive has been well used.
| 4KB Random Write Speed | New | "Used" |
| Intel X25-E | 31.7 MB/s | |
| Intel X25-M | 39.3 MB/s | 23.1 MB/s |
| JMicron JMF602B MLC | 0.02 MB/s | 0.02 MB/s |
| JMicron JMF602Bx2 MLC | 0.03 MB/s | 0.03 MB/s |
| OCZ Summit | 12.8 MB/s | 0.77 MB/s |
| OCZ Vertex | 8.2 MB/s | 2.41 MB/s |
| Samsung SLC | 2.61 MB/s | 0.53 MB/s |
| Seagate Momentus 5400.6 | 0.81 MB/s | - |
| Western Digital Caviar SE16 | 1.26 MB/s | - |
| Western Digital VelociRaptor | 1.63 MB/s | - |
Note that the “used” performance should be the slowest you’ll ever see the drive get. In theory, all of the pages are filled with some sort of data at this point.
All of the drives, with the exception of the JMicron based SSDs went down in performance in the “used” state. And the only reason the JMicron drive didn’t get any slower was because it is already bottlenecked elsewhere; you can’t get much slower than 0.03MB/s in this test.
These are pretty serious performance drops; the OCZ Vertex runs at nearly 1/4 the speed after it’s been used and Intel’s X25-M can only crunch through about 60% the IOs per second that it did when brand new.
So are SSDs doomed? Is performance going to tank over time and make these things worthless?
"Used" SSD performance vs. conventional hard drives.
Pay close attention to the average write latency in the graph above. While Intel’s X25-M pulls an extremely fast sub-0.3ms write latency normally, it levels off at 0.51ms in its used mode. The OCZ Vertex manages a 1.43ms new and 4.86ms used. There’s additional overhead for every write but a well designed SSD will still manage extremely low write latencies. To put things in perspective, look at these drives at their worst compared to Western Digital’s VelociRaptor.The degraded performance X25-M still completes write requests in around 1/8 the time of the VelociRaptor. Transfer speeds are still 8x higher as well.
Note that not all SSDs see their performance drop gracefully. The two Samsung based drives perform more like hard drives here, but I'll explain that tradeoff much later in this article.
How does this all translate into real world performance? I ran PCMark Vantage on the new and used Intel drive to see how performance changed.
| PCMark Overall Score | New | "Used" | % Drop |
| Intel X25-M | 11902 | 11536 | 3% |
| OCZ Summit | 10972 | 9916 | 9.6% |
| OCZ Vertex | 11253 | 9836 | 14.4% |
| Samsung SLC | 10143 | 9118 | 10.1% |
| Seagate Momentus 5400.6 | 6817 | - | - |
| Western Digital VelociRaptor | 7500 | - | - |
The real world performance hit varies from 0 - 14% depending on the drive. While the drives are still faster than a regular hard drive, performance does drop in the real world by a noticeable amount. The trim command would keep the drive’s performance closer to its peak for longer, but it would not have prevented this from happening.
| PCMark Vantage HDD Test | New | "Used" | % Drop |
| Intel X25-M | 29879 | 23252 | 22% |
| JMicron JMF602Bx2 MLC | 11613 | 11283 | 3% |
| OCZ Summit | 25754 | 16624 | 36% |
| OCZ Vertex | 20753 | 17854 | 14% |
| Samsung SLC | 17406 | 12392 | 29% |
| Seagate Momentus 5400.6 | 3525 | - | |
| Western Digital VelociRaptor | 6313 | - |
HDD specific tests show much more severe drops, ranging from 20 - 40% depending on the drive. Despite the performance drop, these drives are still much faster than even the fastest hard drives.
Facebook
Twitter
RSS
250 Comments
View All Comments
sotoa - Friday, April 3, 2009 - link
Long time reader, first time post.I really liked the background story and appreciate how Anand delves deep into the the SSD's (as well as other products in other articles).
Thanks for looking out for the little guy!
Keep up the great work!
siliq - Wednesday, April 1, 2009 - link
With Anand's excellent article, it's clear that the sequential read/write thoroughput doesn't matter so much - all SSDs, even the notorious JMicron series, can do a good job on that metric. What is relevant to our daily use is the random write rate. Latencies and IOs/second are the most important metric in the realm of SSD.Based on that, I would suggest Anand (and other Tech reporters) to include a real world test of evaluating the Random Write performance for SSD. Because current real-world tests: booting windows, loading games, rendering 3D, etc. they focus on the random read. However, measuring how long it takes to install Windows, Microsoft Visual Studio, or a 4-GB PC Game would thoroughly test the Random Write / Latency performance. I think this is a good complementary of our current testing methodology
Sabresiberian - Tuesday, March 31, 2009 - link
Just wanted to add my thanks to Anand for this article in particular and for the quality work he has done over the years; I am so grateful for Anandtech's quality and information and the fact that it has been maintained!Sabresiberian - Tuesday, March 31, 2009 - link
Oops didn't proof, sorry about the misspell Anand!hongmingc - Saturday, March 28, 2009 - link
Anand, This is a great Article and a good story too.The OCZ story caught my attention that a quick firmware upgrade make a big improvement. From my understanding that SSD system designers try to trade off Space, Speed, and Durability (Also SSD :)) due the nature of NAND flash.
We can clearly see the trade off of Space and Speed when SSD is getting more full the slower the speed (This is due to out-of-place write to increase the write operation and a block reclaim routine). However, Speed is also sacrificed to achieve the Durability (by doing wear leveling). Remember SLC nand's life time is about 100K write, while MLC nand has only about 10K write. Without considering doing wear leveling to improve the life cycle of the SSD, the firmware can be much simple and easy which will improve the write operation speed quite a bit.
I echo you that the performance test should reflect user's daily usage which can be small size files write and may not be 80% full.
However, users may be more concern about the Durability, the life cycle of the SSD.
Is there such a test? How long will the black box OCZ Vertex live?
How long will the regular OCZ Vertex live? and How long will the X25 live?
antcasq - Sunday, April 5, 2009 - link
This article was excellent, explaining several issues regarding performance.It would be great if the next article abou ssd addresses durability and reliability.
My main concert is the swap partition (Linux) or virtual memory file (Windows). I found an post in another website saying that this is not an issue. Is it true? I find it hard to believe. Maybe in a real world test/scenario the problem will arise.
http://robert.penz.name/137/no-swap-partition-jour...">http://robert.penz.name/137/no-swap-partition-jour...
I hope AnandTech can take my concerns into consideration.
Best regards
stilz - Friday, March 27, 2009 - link
This is the first hardware review I've read from start to finish, and the time is well worth the information you've provided.Thank you for your honest, professional and knowledgeable work. Also kudos to OCZ, I'll definitely consider the Vertex while making purchases.
Bytales - Friday, March 27, 2009 - link
As i read the article, i'm thinking of ways to slow down the down the degrading process. Intel is gonna ship x-25m 320gb this year. If i buy this drive and use it as an OS drive, i will obviously won't need the whole 320GB. Say i would need only 40 to 50 GB. I can make a secure erase (if the drive isn't new), made a partition of 50GB, and leave the remaining space unpartitioned. Will that solve the problem in any way ?Another way to solve the problem, would be a method inside the OS. The OS could use a user controlled % of the RAM memory, as a cache for those small 4kb files. Since ram reads and writes are way faster, i think it will also help. Say you got 8GB ram, and use 2gb for this purpose, and then the OS would only have 6gb ram for its use, while 2gb is used for these smaller files. That would increase also the lifespan of the SSD. Can this be possible ?
Hellfire26 - Thursday, March 26, 2009 - link
In reference to SSD's, I have read a lot of articles and comments about improved firmware and operating system support. I hope manufacturers don't forget about the on-board RAID controller.From the articles and comments made by users around the web, who have tested SSD's in a Raid 0 configuration, I believe that two Intel X25-M SSD's in a RAID 0 configuration would more than saturate current on-board RAID controllers.
Intel is doing a die shrink of the NAND memory that is going into their SSD's come this fall. I would expect these new Intel SSD's to show faster read and write times. Other manufacturers will also find ways to increase the speed of their SSD's.
SSD's scale well in a RAID configuration. It would be a shame if the on-board RAID controller limited our throughput. The alternative would be very expensive add-in RAID cards.
FlaTEr1C - Wednesday, March 25, 2009 - link
Anand, once again you wrote an article that no one else could've written. This is why I'm reading this site since 2004 and will always do. Your articles and reviews are without exception unique and a must-read. Thank you for this thorough background, analysis and review of SSD.I was looking a long time for a solution to make my desktop experience faster and I think I'll order a 60GB Vertex. 200€(germany) is still a lot of money but it will be worth it.
Once again, great work Anand!